Panasonic SCHC58 Benutzerhandbuch

RQT9754

As a factory preset, this unit will always turn off 
automatically if there is no sound output and no 
operation for approx. 30 minutes.
To cancel this function

Press [SETUP] repeatedly to select 
“AUTO OFF”.

Press [3, 4] to select “OFF” and then press 
[OK].

≥ To turn automatic standby on, select “ON” in step 2.
≥ This setting cannot be selected when “FM” is the source.

The brightness of this unit’s display can be 
changed.

Press [SETUP] repeatedly to select “DIMMER”.

Press [3, 4] to select “ON” and then press 
[OK].

To cancel the dimmer, select “OFF” in step 2.

When other Panasonic equipment responds to the 
supplied remote control, change the remote control 
code.

Press [CD] to select “CD”.

While pressing and holding [SELECTOR] on 
the unit, press and hold [CD/RADIO] on the 
remote control until the unit's display shows 
“REMOTE 2”.

Press and hold [OK] and [CD/RADIO] on the 
remote control for at least 4 seconds.

≥ To change the mode back to “REMOTE 1”, repeat the 

steps above but replace the button pressed on the 
remote control from [CD/RADIO] to [ ].

Occasionally, Panasonic may release updated 
software for this unit that may add or improve the 
way a feature operates. These updates are 
available free of charge.
Preparation
≥ Turn the unit on.
≥ Connect this unit to the wireless network. (

l 8)

jMake sure that the wireless network is 

connected to the Internet.

jIf “D.CONNECT” is set to “ON”, change the 

setting to “OFF” and connect this unit to a 
wireless network that is connected to the 
Internet.

Press [SETUP] repeatedly to select 
“SW UPDATE” and then press [OK].

Press [3, 4] to select “UPDATE? Y” and then 
press [OK] to start the update.

When the update has finished successfully, 
“SUCCESS” is displayed.

Disconnect the AC power supply cord and 
reconnect it after 3 minutes.

≥ Downloading will require several minutes. It may 

≥ If you do not want to update the unit, select 

“UPDATE? N” and then press [OK] in step 2.

≥ If there are no updates, “NO NEED” is displayed after 

step 2.

∫ Checking the software version

1

Press [SETUP] repeatedly to select “SW VER.” 
and then press [OK].

{.

The version of the installed software is displayed.

2

Press [OK] to exit.

– “LINKING”, “UPDATING” or “

%” 

(“   ” stands for a number.)

≥ During the update process, no other operations can be 

performed.

SC-HC58~RQT9754.book  Page 17  Tuesday, December 18, 2012  4:40 PM