Panasonic SCHC58 Benutzerhandbuch

RQT9754

Before requesting service, make the following 
checks. If you are in doubt about some of the check 
points, or if the solutions indicated in the following 
guide do not solve the problem, refer to “Customer 
Services Directory (United States and Puerto Rico)” 
on page 30 if you reside in the U.S.A. or Puerto 
Rico, or refer to “Limited Warranty (ONLY FOR 
CANADA)” on page 31 if you reside in Canada.

≥ Occasionally, Panasonic may release updated software 

for this unit that may add or improve the way a feature 
operates. (l 17)

≥ An AC power supply cord or fluorescent light is near the 

cords. Keep other appliances and cords away from this 
unit’s cables.

≥ Make sure that the disc is compatible with this unit. 

(l 23)

≥ There is moisture on the lens. Wait for about an hour 

and then try again.

≥ Confirm the FM antenna is properly connected. (

l 6)

≥ Adjust the position of the antenna.
≥ Try to keep a certain amount of distance between the 

antenna and AC power supply cord.

≥ Try using an outdoor antenna if there are buildings or 

mountains nearby.

≥ Switch the television or other audio players off or 

separate it from this unit.

≥ Keep this unit away from mobile phones if the 

interference is apparent.

Stations cannot be selected.
Change the FM frequency step.
1 Press [RADIO] to select “FM”.

2 Press and hold [SELECTOR] on the unit.

After a few seconds the display changes to show the 
current lowest frequency. Continue to hold the button 
down. The lowest frequency changes and the step is 
changed.

≥ Have you selected the appropriate selector? 

Press [iPod] to select either “IPOD_DOCK” or 
“IPOD_PORT”.

≥ Check that the iPod/iPhone/iPad is connected properly. 

(l 7)

≥ The battery of the iPod/iPhone/iPad is depleted. Charge 

the iPod/iPhone/iPad, and then operate again.

≥ Connect the iPod/iPhone/iPad again or try to restart the 

iPod/iPhone/iPad.

≥ When this unit is in standby mode, charging will not start 

when using the “IPOD_PORT” connection. Turn this unit 
on and make sure the charging has started before 
switching this unit to standby mode.

≥ Confirm the network connection and settings. (

l 8)

≥ Your wireless network might be set to be invisible. In this 

case select “Manual settings” in “Method 3”. (l 10)

≥ This unit cannot join a wireless network using WEP 

security settings with the WPS methods (“Method 2”). 
Use “Method 3” to join the wireless network. (l 9)

≥ Make sure that the multicast function on the wireless 

network router is set to on (enabled).

≥ When “D.CONNECT” is used, if the password for 

"D.CONNECT" has been changed connect the other 
device to this unit using the new password. (l 12)

To return all settings to the factory preset
When the following situations occur, reset the 
memory:

≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.

1 Disconnect the AC power supply cord. (Wait 

for at least 3 minutes before proceeding to 
step 2.)

2 While pressing and holding down [

Í/I] on the 

unit, reconnect the AC power supply cord.
≥ “--------” appears on the display.

3 Release [

Í/I].

All the settings are returned to the factory preset. You will 
need to reset the memory items.

SC-HC58~RQT9754.book  Page 19  Tuesday, December 18, 2012  4:40 PM