JVC KDC-BT92SD Benutzerhandbuch

|

KDC-BT92SD

English

   

|

   

External Power 
Connector
A-4

Yellow

Battery

A-5

Blue/White

Power Control

A-6

Orange/White

Dimmer

A-7

Red

Ignition (ACC)

A-8

Black

Earth (Ground)
Connection

Speaker 
Connector
B-1

Purple

Rear Right (+)

B-2

Purple/Black

Rear Right (–)

B-3

Gray

Front Right (+)

B-4

Gray/Black

Front Right (–)

B-5

White

Front Left (+)

B-6

White/Black

Front Left (–)

B-7

Green

Rear Left (+)

B-8

Green/Black

Rear Left (–)

2

The pin arrangement for the ISO connectors depends on 
the type of vehicle you drive. Make sure to make the proper 
connections to prevent damage to the unit.
The default connection for the wiring harness is described in 
1

 below. If the ISO connector pins are set as described in 2, 

make the connection as illustrated.
Please be sure to reconnect the cable as shown 2 below to 
install this unit to the Volkswagen vehicles etc.

1

 (Default setting) The A-7 pin (red) of the vehicle’s 

ISO connector is linked with the ignition, and 

the A-4 pin (yellow) is connected to the constant 

power supply.

Unit

Vehicle

A-7 Pin (Red)

A-4 Pin (Yellow)

Ignition cable (Red)

Battery cable (Yellow) 

2

 The A-7 pin (red) of the vehicle’s ISO connector is 

connected to the constant power supply, and the 

A-4 pin (yellow) is linked to the ignition.

Unit

Vehicle

A-7 Pin (Red)

A-4 Pin (Yellow)

Ignition cable 

(Red)

Battery cable 

(Yellow) 

Bend the tabs of the mounting 
sleeve with a screwdriver or similar 
utensil and attach it in place.

⁄

•  Make sure that the unit is installed securely in place. If the

unit is unstable, it may malfunction (for example, the sound 
may skip).

¤

Install this unit in the console of your vehicle. 
Do not touch the metal part of this unit during and 

shortly after the use of the unit. Metal part such as 

the heat sink and enclosure become hot. 

Engage the catch pins on the removal tool and 

remove the two locks on the upper level. 

Upper the frame and pull it forward as shown in 

the figure.

Catch

Lock

Accessory2

Removal tool

When the upper level is removed, remove the 

lower two locations.

⁄

•  The frame can be removed from the bottom side in the

same manner.

Refer to the section <Removing the hard rubber 

frame> and then remove the hard rubber frame.

Detach the faceplate.

Insert the two removal tools deeply into the slots 

on each side, as shown.

Lower the removal tool toward the bottom, and 

pull out the unit halfway while pressing towards 

the inside.

Accessory2

¤

•  Be careful to avoid injury from the catch pins on the

removal tool.

Pull the unit all the way out with your hands, being 

careful not to drop it.