ONKYO CS-265DAB Benutzerhandbuch

En-

31

Press the [TIMER] button repeatedly to 
display “Clock.”
If the clock has not been set yet, only “Clock” 
will appear.

q]/[w] buttons to set the day of 

q]/[w] buttons to set the hour, 

then press the [ENTER] button.
To switch between 24-hour and 12-hour display, 
press the [DISPLAY] button.

q]/[w] buttons to set the minute, 

then press the [ENTER] button.
When you press the [ENTER] button, clock count 
starts from 00 seconds.

If the CD receiver is in standby mode, press the 
[CLOCK CALL] button. The clock time appears on the 
display for about 8 seconds. While the CD receiver is 
turned on, press the [CLOCK CALL] button. The clock 
time is displayed continuously.

Note:
• If a power outage occurs, the clock will stop and 

“-- : --” will appear. Also, all programmed timers will 
be canceled. Set the clock again, and turn on the 
necessary timers.

The CD receiver features a sleep timer that places the 
unit into power standby mode after a specified period of 
time. It also features four programmable timers that 
initiate playback of a specified source at a specified 
volume level at a specified time.

When the sleep timer is enabled, the CD receiver will 
enter power standby mode after a specified period of 
time.

While the power to the CD receiver is on, 
press the [SLEEP] button.
“Sleep 90” appears for about 8 seconds, then the 
unit will enter power standby mode in 90 minutes. 
While the sleep timer is enabled, the SLEEP 
indicator appears on the display.

While the Sleep time is displayed, press 
the [SLEEP] button repeatedly to set the 
desired time.
Each press of the [SLEEP] button will shorten the 
sleep time in 10 minute increments.

To check the remaining sleep time, press the [SLEEP] 
button. You can shorten the sleep time in 10 minute 
increments by pressing the [SLEEP] button while the 
sleep time is displayed.

To cancel the sleep timer, press the [SLEEP] button 
repeatedly until “Sleep Off” appears. If you want to 
power off the CD receiver immediately, press the [

8] 

button.

Before programming a timer, you must set the clock. 
(see page 31) Also, if you plan to program a timer for 
DAB or FM, first you must preset the desired DAB or 
FM broadcast stations (see page 27).

Press the [TIMER] button repeatedly to 
select a timer number (1–4).
If only “Clock” appears, the clock has not been 
set yet. Set the clock first (see page 31).

[q]/[w] buttons to select “On”, 

Mon

Tue

Wed

Thu

Fri

Sat

Sun