Tandberg Data 1080P Benutzerhandbuch
D14640.01—MARCH 2010
22
TANDBERG PrecisionHD 1080p/720p camera
Camera User Guide
Contents
Introduction
Physical interface
Cables
Connecti to codec
Video formats
Daisy chaining
Appendices
Contact us
www.tandberg.com
The VISCA™/RS–232 control protocol, cont...
Network and interface commands
Push messages
Messages sent from camera to controller.
Command set
Command packet
Comments
IF_Clear
8x 01 00 01 ff
Clear command buffer. Stop any
current operation in progress. Does not
do much on Rover.
current operation in progress. Does not
do much on Rover.
Address_Set
8x 30 0p ff
p = address for this device. If x=8
(broadcast), increase p with 1 before
sending to chain.
(broadcast), increase p with 1 before
sending to chain.
Command_
Cancel
Cancel
8x 2p ff
p = Socket ID. Rover does not support
multiple sockets. Commands will
always run to completion. Don’t use it
multiple sockets. Commands will
always run to completion. Don’t use it
Command set
Command packet
Reply and comments
Network_
Change
Change
y0 38 ff
This indicates that cameras have been added
to or removed from the chain.
It is recommended to wait 9 seconds after
receiving this message before doing a full
reconfigure.
to or removed from the chain.
It is recommended to wait 9 seconds after
receiving this message before doing a full
reconfigure.
IR_Push
y0 07 7d 02 gg hh ff
If IR mode is on, IR codes received by the
camera will be sent to the controller.
gg = IR ID
hh = keycode
camera will be sent to the controller.
gg = IR ID
hh = keycode
Contact us
Contents
Introduction
Cables
Daisy chaining
Appendices
Physical interface
Connect to codec
Video formats
Appendices