Snapper 1691530 Benutzerhandbuch
NOTE
Not all hardware supplied with horn kit will be used
for this installation. Discard excess hardware.
Refer to
for this installation. Discard excess hardware.
Refer to
1 to familiarize yourself with the
assembly.
NOTE
On newer gear models, battery is not located in rear
compartment (see figure 3). This allows installation
by either of the following methods.
compartment (see figure 3). This allows installation
by either of the following methods.
HORN INSTALLATION Early Gear Models
1 . Install the two mounting plates (A, figure 2) together
and install onto the shift cable mounting bracket
using the
using the
nut and
(B).
Mount the horn by inserting it through the mounting,
plates (A) and installing lockwasher and nut (D).
Then, connect one end of the 45 inch black wire to,
Then, connect one end of the 45 inch black wire to,
either horn terminal (C).
Figure 2.
A. Mounting Plates
A. Mounting Plates
C. Terminal
D. Nut
3. Route the 45 inch wire along with other wires along
right-hand side of frame and under footrest (figure
4.
Go to HORN BUTTON INSTALLATION
All
Models.
Figure 3. Early Gear Models
A. Horn
B . W i r e
HORN INSTALLATION
Models
1 . Connect the horn (A,
1) to the mounting plates
with lockwasher (M) and nut (N).
2. Connect the L-bracket (P, figure 1) to the mounting
plates (L) with lockwasher
and nut (N).
3. Install the horn as shown in
4 as follows.
a. Locate the existing screw and retainer under the
rear edge of footrest.
Figure 4.
Models
Figure 4.
Models
A. Horn
A. Horn
B. Mounting Straps
B. Mounting Straps
C. Wire
C. Wire
D. Terminal
D. Terminal