Snapper 1691530 Benutzerhandbuch
b. Remove this existing screw, and install new
16-
18 1 screw
being sure the retainer is in
original position.
c. Place the horn assembly into position onto the
screw and install the flange
nut(E). The
horn should appear as in
4.
4.
the
wire(C) to either horn terminal
Route the wire, under the footrest as shown.
5. Go to HORN BUTTON INSTALLATION
All
Models.
HORN BUTTON INSTALLATION All Models
1 . Remove the dash plate (A, figure 5) by removing six
screws (B). Disconnect plug from ignition switch.
2. Drill a
16 inch hole in the dash plate to install
horn button (C,
5) (shown installed). Measure
2 inches down from center of ignition switch. Then
measure
measure
inch to left. Drill hole at that point.
3. Install the
button in the hole by inserting the
button and securing with nut. Be sure terminals point
down before tightening nut.
down before tightening nut.
Figure 5.
A. Dash Plate
(6)
C. Horn Button
D. Light Switch (Optional)
4. Route the
black wire (A, figure 6) up into
column
hole in frame.
Figure 6.
A. Wire
5. Connect the 45 inch black wire to either terminal of
the horn button.
6 . Connect the red wire supplied with kit onto the other
terminal of the horn button.
7. In this step, you will be connecting the red wire
installed in step 6 to an existing red wire that goes to
the ignition switch, using the self-stripping connector
supplied with kit.
the ignition switch, using the self-stripping connector
supplied with kit.
a. Notice that in one terminal of the ignition switch
plug, there is a red and violet wire (this is the
terminal marked on switch). This is the red wire
you’ll be using.
terminal marked on switch). This is the red wire
you’ll be using.
b. Notice that the self-stripping connector has one
hole that does not go all the way through. Insert
red wire installed in step 6 into thii hole. Then,
place the
red wire installed in step 6 into thii hole. Then,
place the
onto the red wire from
ignition switch and press closed with a pliers (red
wire will extend out both ends of connector.)
wire will extend out both ends of connector.)
8. Install the plug onto ignition switch. Install the panel
with the six screws.
9. This completes the installation.