Snapper 60943 Benutzerhandbuch

#6-0943 SINGLE BAG GRASS CATCHER KIT for

28" & 33" REAR ENGINE RIDERS AND LAWN TRACTORS

This Single Bag Grass Catcher Kit fits SNAPPER 28” & 33” Rear Engine Riders. It also fits SNAPPER Tractors

provided the tractor is equipped with the rear mount adapter kit & has 33" mower. Kit #6-1068 is required for

the Disc & Hydro Drive Lawn Tractors series 0, 1 & 2. Kit #6-0875 is required for Yard & Garden Tractors series.

Kit #6-1334 is required for Tractors series "A", "B", "C" & "D".

WARNING

Before attempting any adjustments, maintenance, service, or repairs, stop engine and blade, always remove

key from ignition switch, remove spark plug wire(s) and secure wire(s) away from spark plug(s). Engine,

muffler and surrounding areas are extremely hot. Allow components to cool down before installing kit. Load

Carrier Kit #6-0197 with 50 pounds MUST be installed prior to operating machine with catcher on slopes. DO

NOT operate machine on slopes exceeding 10 degrees (18% grade) when equipped with grass catcher. DO

NOT operate machine without entire grass catcher or deflector in place. Inspect all grass catcher components

frequently for signs of wear and deterioration. Replace worn or damaged components immediately.

STEP 1: BUMPER REINFORCEMENT BRACKET &

MUFFLER GUARD INSTALLATION (USED ON REAR

ENGINE RIDERS ONLY)

Remove the two screws securing the right side rear

bumper. Remove screw from right rear panel. Install

bumper reinforcement bracket and secure to right rear

panel, secure with screw. See Figure 1. Place muffler

shield against bumper reinforcement bracket and right

side rear bumper, install screws. Tighten securely. See

Figure 1.

FIGURE 1

STEP 2: REMOVAL OF DEFLECTOR (Tractors Only)
A. Remove the hinge nut, spring and hinge pin from
deflector. Remove deflector. Remove wing nut, flat
washer, bolt retainer and bolt from deck. Save for future
use when not bagging grass. See Figure 2A.

FIGURE 2A

Note: The deflector on rear engine riders need not be
removed (except on some older models). Lift the deflector
up and out of the way before installing adapter.
B. ADAPTER INSTALLATION
Install the previously removed bolt into the hole in the
center of the discharge opening. See Figure 2B.

FIGURE 2B

INSTRUCTION No. 2-3822 (Rev. 6, 6/11/99)

REAR ENGINE
RIDER SHOWN

BUMPER
REINFORCEMENT

MUFFLER
SHIELD

RIGHT SIDE
REAR BUMPER

HINGE
NUT

SPRING

FLAT WASHER

WING NUT

DEFLECTOR

HINGE
PIN

33” DECK

BOLT

BOLT RETAINER
(DISCARD)

INSTALL BOLT

33” DECK