Snapper 60943 Benutzerhandbuch

 

C.   ADAPTER INSTALLATION 
Hold the adapter in front of the deck. Align the adapter 
lugs with the hinge lug retainers, and then push the 
adapter to the rear.  
 

Loosen bolts (see Figure 2C) & bump the adapter, if 
necessary, to force the lugs under the lug retainers. 
Secure the adapter to the deck with a flat washer and 
wing nut. Tighten bolts. See Figure 2C. 

 

STEP 3: COVER/FRAME INSTALLATION 
Lower cover/frame structure into position on bumper. Secure each side of structure as follows: Insert one 5/16 x 1-11/16” 
clevis pin through top hole at each side of cover/frame structure as shown in Figure 3 and secure with 3/32 x 1-1/2” hairpin 
cotter. 
 
NOTE:  When Rear Engine Rider is equipped with two-piece post style bumper (as shown in Figure 1) install clevis pin in 
lower hole at each side of cover/frame structure.