Woods Equipment CZR2242B Benutzerhandbuch

35

1.  Park the machine on a smooth, level surface.  

Raise the deck to the transport position.

2.  Lower the deck onto a set of equal height blocks  

under the rear corners of the deck.  Place an-
other set of blocks under the front of the deck so 
that the deck top is pitched forward 1/8".

NOTE: The front and rear of the deck are at different 
heights.

3.  Measure the height of the blade cutting edge 

above the ground.  Remove pin B and set the 
height of cut lever E to that height

4.  Loosen nuts on bolts G.  Move bolts in slot to 

remove slack in chain.  Tighten nuts on bolts G.

The height of cut is set by moving height of cut pin B 
to the hole designated for the height of cut desired.  

To change the height of cut:
1.  Lift the deck to the highest position.
2.  Move pin B to the selected hole.  
3.  Lower the deck until the lift lever is stopped by 

the pin.

NOTES:  

- 

Height of cut may vary due to the amount of 

tread on the tires, tire diameter or inflation pres-
sure.

The deck rollers are adjustable up and down to 

provide improved deck flotation and scalping protec-
tion at various heights of cut.  They are not intended 
to ride continuously on the ground.  Adjust no closer 
than 3/8" (10mm) to the ground.