Woods Equipment CZR2242B Benutzerhandbuch

36

NOTE:  There are 2 brakes, 1 on each transaxle.

The parking brake should keep the machine from 
moving.  To check the parking brake, park the ma-
chine on a level surface, open the bypass valves and 
set the parking brake to ON.  Attempt to move the 
machine forward and backward by pushing it.  If the 
machine moves, adjust the parking brake linkage as 
follows:

1.  Move the machine to a flat horizontal surface.

2.  Grip the flats on the brake rod A.  Tighten nut 

B on the brake rod until you run out of threads.  
See Figure 1 for detailed view.

3.  Move the parking brake handle to the OFF 

position.  

4.  Loosen nut X.

5.  Hold brake arm in the OFF position as shown in 

Figure 2.

6.  Adjust swivel U until swivel stud meets brake arm 

hole in the OFF position.

7.  Insert cotter pin into swivel U.

8.  Tighten nut X.

9.  Repeat Steps 1-8 on the opposite side.