Alamo 02968915C Benutzerhandbuch

MACHETE BOOM 3/09

Operation Section 3-39

©2009 Alamo Group Inc.

•

The Flail  Brush Cutter is rated to cut material 
up to 4” in diameter.  

•

Setting cutting height ranges from 3/4” to 6”.  
Cutting height is set by adjusting the height of 
the roller assembly.

•

Remove roller assembly when cutting limbs 
and other large diameter vegetation (greater 
than 2”) to prevent damaging the roller 
assembly.

•

When operating near the ground or when 
mulching be particularly careful that there are 
no bystanders or animals within a 100 yards. 
Debri tends to fly out at great speed and can 
injure or even cause death.   OPS-B- 0042

•

The BuzzBar Tree Limb Cutter is rated for 
material up to 4” in diameter.

•

Suggested cutting Speed for the Buzzbar is 1st 
gear.  Slow down for thick, dense, or hard 
material.

•

Always cut with the boom positioned 
perpinducular to the limbs being cut (see 
diagram).  Cutting with the boom swing 
backward or forward will cause the blades to 
warp from “raking” through the cut material.

•

For maximum blade life, do not allow the 
blades to contact hard items such as the 
ground or metal objects.

•

Check belt tension daily.If belts start to slip 
adjust tension soon.  The more belt slippage, 
the more they will wear and looser they 
become.  

•

Grease bearings of saw blade spindles daily.

•

Two pumps from hand grease gun.

•

When operating the unit be sure there are no 
bystanders or animals with in 100 yards of the 
unit

.