Alamo Exten-A-Kut II Benutzerhandbuch
ASSEMBLY
EK II 03/09
Assembly Section 4-9
©2009 Alamo Group Inc.
ASSEMBL
Y
Oil Reservoir is shipped filled with oil to the minimum level. When adding hydraulic oil proceed.
1. Remove the Filler Cap Weldment. FIGURE Asm-B-0007.
2. Avoid hydraulic contamination by filtering the hydraulic oil while filling the hydraulic tank. Filter buggies
or carts are commercially available for hydraulic system clean-up. These consist of a high-efficiency, high-
capacity filter, a circulating pump, a drive motor, and hoses for connecting to the overhauled machine's
hydraulic system. FIGURE Asm-B-0008 & Asm-B-0009
.
2. Avoid hydraulic contamination by filtering the hydraulic oil while filling the hydraulic tank. Filter buggies
or carts are commercially available for hydraulic system clean-up. These consist of a high-efficiency, high-
capacity filter, a circulating pump, a drive motor, and hoses for connecting to the overhauled machine's
hydraulic system. FIGURE Asm-B-0008 & Asm-B-0009
.
3. When adding hydraulic oil, use only new oil from a sealed barrel. Used oil or oil from an open barrel
may contain high levels of contamination. Transfer the oil into the hydraulic tank by using a hydraulic filter
pump unit equipped with a properly operating 10 micron filter. This will insure that the oil being added is
clean. Do not just pour the oil directly into the hydraulic tank since most oils (even from a sealed barrel)
have contaminants that should be removed, before operating the hydraulic system.
may contain high levels of contamination. Transfer the oil into the hydraulic tank by using a hydraulic filter
pump unit equipped with a properly operating 10 micron filter. This will insure that the oil being added is
clean. Do not just pour the oil directly into the hydraulic tank since most oils (even from a sealed barrel)
have contaminants that should be removed, before operating the hydraulic system.