Husqvarna PF 21 AWD Benutzerhandbuch
30 –
English
Maintenance
Replacing the light bulbs
For information about the bulb type, see Technical Data.
1
Unscrew the two screws holding the cover on the power
servo housing.
servo housing.
2
Lift up the cover and turn it around the steering shaft.
3
Unscrew the two screws holding the lamp insert.
4
Lift out the lamp insert.
5
Disconnect the cables from the bulbs.
6
Lift out the bulbs from the insert.
7
Insert the new bulbs. Make sure you use your thumb to
support the front.
support the front.
8
Refit the cables, lamp insert and the cover on the power
servo housing.
servo housing.
Main fuse
The main fuse is placed in a detachable holder under the
battery case’s cover, in front of the battery. Type: Flat pin, 15
A.
battery case’s cover, in front of the battery. Type: Flat pin, 15
A.
The fuse for the power outlet is placed under the ignition
switch, behind the side plate on the control panel. Type: Flat
pin, 7,5 A.
switch, behind the side plate on the control panel. Type: Flat
pin, 7,5 A.
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse
from the holder when replacing.
from the holder when replacing.
The fuse is there to protect the electrical system. If it blows
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
again shortly after replacement, it is due to a short circuit,
which must be fixed before the machine can be put into
operation again.
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar/8.5 PSI) all
round. To improve driving the pressure on the rear tyres can
be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
round. To improve driving the pressure on the rear tyres can
be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.
blades cutting the grass at different heights.