Husqvarna PF 21 AWD 用户手册

30 – 

English

For information about the bulb type, see Technical Data.

1

Unscrew the two screws holding the cover on the power 
servo housing.

2

Lift up the cover and turn it around the steering shaft.

3

Unscrew the two screws holding the lamp insert.

4

Lift out the lamp insert.

5

Disconnect the cables from the bulbs.

6

Lift out the bulbs from the insert.

7

Insert the new bulbs. Make sure you use your thumb to 
support the front.

8

Refit the cables, lamp insert and the cover on the power 
servo housing.

The main fuse is placed in a detachable holder under the 
battery case’s cover, in front of the battery. Type: Flat pin, 15 
A.

The fuse for the power outlet is placed under the ignition 
switch, behind the side plate on the control panel. Type: Flat 
pin, 7,5 A.

Do not use any other type of fuse when replacing.

A blown fuse is indicated by a burnt connector. Pull the fuse 
from the holder when replacing.

The fuse is there to protect the electrical system. If it blows 
again shortly after replacement, it is due to a short circuit, 
which must be fixed before the machine can be put into 
operation again.

The tyre pressure should be 60 kPa (0.6 bar/8.5 PSI) all 
round. To improve driving the pressure on the rear tyres can 
be reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre 
pressure is 100 kPa (1,0 bar/14 PSI).

Different tyre pressures on the front tyres will result in the 
blades cutting the grass at different heights.