Husqvarna Z 246i Benutzerhandbuch
General
When lubricating with an oil can, it must be filled with engine
oil.
When lubricating with grease, unless otherwise stated, use a
high grade molybdenum disulphide grease.
For daily use, the machine should be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or
the drive surfaces of the belt pulleys. Should this happen,
attempt to clean them with spirits. If the belt continues to slip
after cleaning, the belt must be replaced. Gasoline or other
petroleum products must not be used to clean belts.
When lubricating with an oil can, it must be filled with engine
oil.
When lubricating with grease, unless otherwise stated, use a
high grade molybdenum disulphide grease.
For daily use, the machine should be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or
the drive surfaces of the belt pulleys. Should this happen,
attempt to clean them with spirits. If the belt continues to slip
after cleaning, the belt must be replaced. Gasoline or other
petroleum products must not be used to clean belts.
12/12 Every year
Lubricate with
grease gun
grease gun
1/52
Every Week
Filter change
1/365 Every day
Oil change
Level check
IMPORTANT INFORMATION Use minimal lubrication
and remove excess lubricant so that is does not come into
contact with belts or belt pulley drive surfaces.
and remove excess lubricant so that is does not come into
contact with belts or belt pulley drive surfaces.
Transmission
The transmission is maintenance free with no need for level
checks or oil changes. If a leak occurs, replace the unit or
contact your Husqvarna dealer.
checks or oil changes. If a leak occurs, replace the unit or
contact your Husqvarna dealer.
Wheel and Deck Zerks
Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Lubricate 3-4 strokes with a grease gun on each set of wheel
bearings.
bearings.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each set of wheel
bearings.
bearings.
Deck Spindles
Lower the cutting deck completely.
Lubricate with a grease gun, 2-3 strokes per spindle.
Lubricate with a grease gun, 2-3 strokes per spindle.
31
LUBRICATION