Husqvarna Z 246i 用户手册

General
When lubricating with an oil can, it must be filled with engine 
oil.
When lubricating with grease, unless otherwise stated, use a 
high grade molybdenum disulphide grease.
For daily use, the machine should be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or 
the drive surfaces of the belt pulleys. Should this happen, 
attempt to clean them with spirits. If the belt continues to slip 
after cleaning, the belt must be replaced. Gasoline or other 
petroleum products must not be used to clean belts.

12/12 Every year

Lubricate with 
grease gun

1/52

Every Week

Filter change

1/365 Every day

Oil change

Level check

IMPORTANT INFORMATION  Use minimal lubrication 
and remove excess lubricant so that is does not come into 
contact with belts or belt pulley drive surfaces.

The transmission is maintenance free with no need for level 
checks or oil changes. If a leak occurs, replace the unit or 
contact your Husqvarna dealer.

Use only good quality bearing grease.
Grease from well-known brand names (petrochemical 
companies, etc.) usually maintains a good quality.

Lubricate 3-4 strokes with a grease gun on each set of wheel 
bearings.

Lubricate 3-4 strokes with a grease gun on each set of wheel 
bearings.

Lower the cutting deck completely.
Lubricate with a grease gun, 2-3 strokes per spindle.

31

LUBRICATION