Dixon 30 KOH/968999591 Benutzerhandbuch
English
-
53
MAINTENANCE
To adjust anti-scalp rollers
Anti-scalp rollers are properly adjusted when they are
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
just slightly off of the ground when the deck is at the
desired cutting height in the operating position. Anti-
scalp rollers then keep the deck in the proper position
to help prevent scalping in most terrain conditions.
IMPORTANT INFORMATION
Adjust Anti-scalp rollers with the mower
on a fl at level surface.
on a fl at level surface.
IMPORTANT INFORMATION
The anti-scalp rollers must not be used
for gauge wheels or the roller and deck
may be damaged.
for gauge wheels or the roller and deck
may be damaged.
CZ-9
Anti-scalp roller
The anti-scalp rollers can be set in three positions:
•
Upper position 1½ to 3" (38 to 76 mm) grass.
•
Middle position 3" to 4½" (76 to 114 mm) grass.
•
Lower position 4½" to 6" (114 to 152 mm) grass.
The rollers should be approximately ¼" (6.5 mm) from
ground. Do not adjust the rollers to support the deck.
ground. Do not adjust the rollers to support the deck.
Engine oil cooler
Kohler engine only.
1. Clean the outside of fi ns with a brush.
2. Remove the two screws holding the cooler unit to
the blower housing.
3. Tilt the cooler downward.
4. Clean the inside of the cooler with a brush or with
compressed air.
5. Reinstall the oil cooler to the blower housing.
8011-472
Engine oil cooler