Dixon D25K48YT Benutzerhandbuch

WARNING: Lead-acid batteries gen-

If your battery is too weak to start the engine, it should be 

recharged. (See "BATTERY" in the MAINTENANCE sec-

 tion of this man u al).
If “jumper ca bles” are used for emer gen cy starting, follow 

this pro ce dure:

IMPORTANT:  YOUR TRACTOR IS EQUIPPED WITH A 12 

VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 

VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO 

START OTHER VEHICLES. 

TO ATTACH JUMPER CABLES -

 •  Connect one end of the RED cable to the POSITIVE 

(+) terminal of each battery(A-B), taking care not to 

short against tractor chassis.

  •  Connect one end of the BLACK ca ble to the NEGA TIVE 

(-) terminal (C) of fully charged battery.

 •  Connect the other end of the BLACK cable (D) to good 

chassis ground,  away from fuel tank and bat tery.

TO REMOVE CABLES, REVERSE ORDER -

 •  BLACK cable first from chassis and then from the fully 

charged battery.

 •  RED cable last from both batteries.

•  Lift hood to raised position.
•  Remove terminal cover.
•  Disconnect BLACK battery cable then RED battery 

cable and carefully remove battery from tractor.

•  Install new battery with terminals in same position as 

old battery.

•  Reinstall terminal cover.
•   First connect RED battery cable to positive (+) battery 

terminal with bolt and nut as shown. Tighten securely.

• 

Connect BLACK grounding cable to negative (-) bat tery 

terminal with remaining bolt and nut. Tighten securely

• Close 

hood.