Dixon 433616 Benutzerhandbuch

Gauge wheels  are properly adjusted when they are slightly 

off the ground when mower is at the desired cutting height in 

operating position. Gauge wheels then keep the deck in prop-

er position to help prevent scalping in most terrain conditions. 
NOTE:Adjust gauge wheels with tractor on a flat level 

surface.
•  Adjust mower to desired cutting height (See “TO AD-

 JUST MOWER CUT TING HEIGHT” in the Operation 

sec tion of this manual).

•  With mower in desired height of cut po si tion, gauge 

wheels should be assembled so they are slightly off 

the ground. In stall gauge wheel in appropriate hole as 

shown and tighten se cure ly.

• 

Repeat for opposite side installing gauge wheel in same 

adjustment hole.

The direction and speed of movement is controlled by the 

forward and reverse drive pedals.
•  Start tractor and release parking brake.
• 

Slowly depress forward (K) or reverse (L) drive pedal to 

begin movement. Ground speed increases the further 

down the pedal is depressed.

The cruise control feature can be used for forward travel only.
SYSTEM CHARACTERISTICS
The cruise control should only be used while mowing or 

transporting on relatively smooth, straight surfaces. Other 

con di tions such as trimming at slow speeds may cause the 

cruise control to dis en gage. Do not use the cruise control 

on slopes, rough terrian or while trimmimg or turning.
• 

With forward drive pedal depressed to desired speed, 

pull cruise control lever (J) up and hold while lifting 

your foot off the pedal, then release the lever.

To disengage the cruise control, depress the brake pedal 

or tap on forward drive pedal.

Your tractor is equipped with an operator presence sensing 

switch.  Any attempt by the operator to leave the seat with 

the engine running and the attachment clutch engaged will 

shut off the engine. You must remain fully and centrally 

positioned in the seat to prevent the engine from hesitat-

ing or cutting off when operating your equipment on rough, 

rolling terrain or hills.
• 

Select desired height of cut (see "TO ADJUST MOWER 

CUTTING HEIGHT")

•  Start mower blades by engaging at tach ment clutch 

control.

The position of the attachment lift lever (A) determines the 

cutting height.

•  Put attachment lift lever in desired cutting height slot.
The cutting height range is ap prox i mate ly 1" to 4". The 

heights are measured from the ground to the blade tip with 

the engine not running. These heights are approximate and 

may vary depending upon soil conditions, height of grass 

and types of grass being mowed.
•  The average lawn should be cut to approximately 

2-1/2" during the cool season and to over 3" during hot 

months. For healthier and better looking lawns, mow 

often and after moderate growth.

•  For best cutting performance, grass over 6" in height 

should be mowed twice. Make the first cut relatively 

high; the second to de sired height.