Dixon CE RAM Benutzerhandbuch

Uncrate machine.

1 - Top Loop
1 - Left Side Post
1 - Right Side Post
1 - Hardware Bag
    2 - 1/2’’ Latch Pins w/lanyard
    6 - 1/2C x 3 1/4’’ Cap screws
    6 - 1/2C Centerlock Nuts
    2 -  Knobs
(all hardware Grade 5).

1. Remove roll bar and parts bag from the box.
2. Install roll bar side posts.

a. Locate the LEFT and RIGHT side posts.
b. Slide the left side post into the left side

receiver on the frame, do the same on
the right side.

c. Using 1/2C x 3 1/4 cap screws, two per

post, align the holes in the side post with
the frame receiver.

d. Install the 1/2C centerlock nuts finger tight

to the side post bolts.

3. Install roll bar top loop.

a. Align the holes of the top loop with the left

and right side posts.

b. Slide the latch pins through the front hole

on the left and right side to connect the
top loop to the side posts. Secure with
the hairpin.

c. Using 1/2C x 3 1/4 cap screws through

the rear hole on the left and right side.

d. Install the 1/2C centerlock nuts finger

tight.

4. Torque all 1/2’’ hardware to 80 ft./lbs. (110 N•m).
5. Install and tighten knobs against the side

post.