Troy-Bilt 769-03253 Benutzerhandbuch

IMPORTANT: The snow thrower is shipped with oil and 
WITHOUT GASOLINE. After assembly, refer to separate 
engine manual for proper fuel and engine oil recom-
mendations.

•  The augers are secured to the auger shaft with shear 

pins and bow tie cotter pins. If you hit a foreign object 
or ice jam, the snow thrower is designed so that the 
pins may shear. Replacement shear pins and cotter 
pins are provided for your convenience. Store these 
safely until needed.

Pair of pliers  

7/16” Wrenches or adjustables 

Fresh gasoline

•  Disconnect the spark plug wire and ground it against 

the engine to prevent unintended starting.

•  Reference to the right hand or left hand side of 

machine are observed from the operating position.

•  Look at the lower rear of the snow thrower frame to 

be sure the spring (found at the end of each cable) is 
attached to its actuator bracket. 

•  Remove the lower handle knobs, washers and 

carriage bolts from each side of the lower handle. See 
Figure 2.

•  Raise the upper handle assembly until it locks over 

the lower handle.  See Figure 1.

•  Secure the upper handle and lower handle with the 

handle knobs and carriage bolts previously removed. 

•  Tighten the handle knobs already in place on the 

upper holes and secure the handles firmly.

•  Remove the hairpin clip from the upper chute crank 

and slide the upper chute crank into the lower chute 
crank. A pair of pliers may help in this job. See Figure 
3.
a.  Align the two holes on both chute cranks. See 

Figure 3.

b.  Secure with the hairpin clip removed earlier.

NOTE: This Operator’s 
Manual covers several 
models. Snowthrower 
featrues vary by model.  
Not all features refer-
enced in this manual 
are applicable to all 
snowthrower models.

NOTE: References to 
right or left side of the 
snow thrower are deter-
mined from behind the 
unit in the operating 
position.

NOTE: Replacement 
auger shear pins and 
cotter pins are provided 
for your convenience. 
Store these safely until 
needed.