Troy-Bilt 769-08234 Benutzerhandbuch

2. 

Align the holes in the chute base with the holes in the 

lower chute and secure with the previously removed hex 

washer screws. See Figure 3-4.

To install the chute rotation control (only models so equipped) 

proceed as follows:
1. 

Remove the hex lock nut and machine screw from the 

chute rotation control. See Figure 3-5.

2. 

Place the chute rotation control onto the chute rotation 

rod and secure with the hex lock nut and machine screw 

removed in step 1. See Figure 3-5.

1. 

Remove the carriage bolts and flange lock nuts from the 

drift cutters.

2. 

Install the drift cutters and secure with the carriage bolts 

and flange lock nuts removed in step 1. See Figure 3-6.

1. 

Remove the eye bolt and handle knob from the manual 

bag.

2. 

Place the eye bolt and handle knob on the upper handle as 

shown in Figure 3-7. Do not fully tighten the hardware until 

instructed to do so.

NOTE: The opening of the eye bolt should face toward the 

back of the snow thrower.