Troy-Bilt Squall2100 Benutzerhandbuch

1. 

Run the snow thrower until the fuel tank is empty.

2. 

Pull the recoil starter handle until resistance is felt. Then tip 

the snow thrower back until it rests on the handles.

3. 

Slide a board up through the auger and through the chute 

to secure the auger in place.

4. 

Remove the belt cover by removing the two hex washer screws 

and one hex lock screw that secure it to the frame. See Fig. 7-1. 

5. 

Remove the flange nut that secures the auger pulley to the 

auger shaft. See Fig. 7-2.

6. 

Remove the auger pulley and the belt.

To replace the belt follow these instructions and refer to Fig. 7-3:

1. 

Route the belt around the drive pulley and under the idler 

pulley.

2. 

Route the end of the belt around the auger pulley and slide 

the pulley back on to the auger shaft. It may be necessary 

to push down on the idler pulley to get the auger pulley 

under the belt keeper.

3. 

Replace the flange nut and tighten securely.

4. 

Reinstall the belt cover removed earlier.

5. 

Remove the board from the auger and chute.