Troy-Bilt 9528 Benutzerhandbuch

6

 Two replacement auger shear pins are 

included with this manual (or stowed in the plastic 
handle panel). Refer to Augers on page 19 for more 
information regarding shear pin replacement.

Prior to operating your snow 

thrower, refer to Auger Control Test on page 11. 
Read and follow all instructions carefully and 
perform all adjustments to verify your snow 
thrower is operating safely and properly.

1.

Observe the lower rear area of the snow thrower to 
be sure both cables are aligned with roller guides 
before pivoting the handle upward.

2.

Secure the upper shift rod to the lower shift rod by 
sliding the connector sleeve downward.

•

Secure the handle by tightening the plastic wing 
knob located on both the left and right sides of the 
handle. Remove and discard any rubber bands, if 
present. They are for packaging purposes only.

3.

Apply a light lubricant (i.e. 3-in-1 oil) to the rim/lip of 
the chute base (and the underside of the chute 
assembly) and position the chute assembly over 
the base.

4.

Close the flange keepers to secure the chute 
assembly to the chute base. The flange keepers 
will click into place when properly secure.