Troy-Bilt 9528 Benutzerhandbuch
7
NOTE:
If the flange keepers will not easily click into
place, use the palm of your hand to apply swift, firm
pressure to the back of each.
pressure to the back of each.
5.
Remove the clevis pin and hairpin clip from the
upper portion of the chute mast.
upper portion of the chute mast.
•
Position the control head over the chute mast and
rear portion of the chute assembly.
rear portion of the chute assembly.
•
Re-insert the clevis pin and secure with the hairpin
clip removed earlier.
clip removed earlier.
CAUTION:
Prior to operating your snow
thrower, refer to Auger Control Test on page 11.
Read and follow all instructions carefully and
perform all adjustments to verify your snow
thrower is operating safely and properly.
Read and follow all instructions carefully and
perform all adjustments to verify your snow
thrower is operating safely and properly.
Tire Pressure
•
Before operating, check tire pressure and reduce
pressure in both tires to between 15 psi and 20 psi.
pressure in both tires to between 15 psi and 20 psi.
NOTE:
If the tire pressure is not equal in both tires,
the unit may not travel in a straight path and the shave
plate may wear unevenly.
plate may wear unevenly.
5