Troy-Bilt 23AABA6X711 Benutzerhandbuch

A discharge chute, wire spring, and chute band, have been 

included with this attachment.  Please assemble them now 

by installing the discharge chute onto the snow thrower by 

following these steps:
1. 

Install the wire spring into the discharge opening 

of the snow thrower by inserting both ends into the 

slots provided. See Figure 3-1 for proper location and 

orientation of the spring. The inset of Figure 3-1 shows the 

spring properly installed with the ends fitted into the slots 

provided.

2. 

Install the discharge chute, packed loose in the carton, 

onto the snow thrower attachment, as shown in Figure 3-3.
Note: Position the discharge chute at an angle to the right 

for ease of installation.

3. 

Clip the discharge chute handle onto the discharge chute, 

as shown in Figure 3-2.

Note: Place a dab of white lithium grease (included with 

this attachment) onto the chute ring, chute spring, and 

chute adapter ring prior to assembly.

4. 

Install the chute band as shown in Figure 3-4. With the 

discharge chute positioned to the right as shown, install 

the chute band by lining up the notches in the front with 

the band, and making certain to fit the discharge chute 

inside the channel of the chute band, as detailed in the 

inset of Figure 3-4.