Troy-Bilt 23AABA6X711 Benutzerhandbuch

5. 

Secure the chute band to itself by first aligning the two 

snap-fit features and pushing the two ends (1 & 2) together 

as shown. Be sure both tabs on the two ends engage each 

other, as shown in the top left inset of Figure 3-5. When 

properly assembled, the chute band will appear as in the 

top right inset of Figure 3-5.

If you need to remove the chute for any reason, 

a screw driver must be used to release the locking tabs shown 

above in the left inset of Figure 3-5.

Note: If the installation has been completed properly, a 

click! click! click! sound will be heard when rotating the 

chute to the left and right. See Figure 3-6.

The snow thrower skid shoes are adjusted upward at the factory 

for shipping purposes. Adjust them downward, if desired, prior to 

operating the snow thrower attachment.

: It is not recommended that you 

operate this snow thrower attachment on gravel as 

it can easily pick up and throw loose gravel, causing 

personal injury or damage to the snow thrower and 

surrounding property.

• 

For close snow removal on a smooth surface, raise skid 

shoes higher on the auger housing.

• 

Use a middle or lower position when the area to be cleared 

is uneven, such as a gravel driveway
NOTE: If you choose to operate the snow thrower on 

a gravel surface, keep the skid shoes in position for 

maximum clearance between the ground and the shave 

plate.

Operating a snow thrower equipped 

with steel skid shoes may result in damage to 

natural stone paver surfaces (e.g. sandstone, 

bluestone, limestone). Refer to the Replacement 

Parts or Attachments & Accessories sections for 

information on available polymer skid shoes.

To adjust the skid shoes:
1. 

Loosen the four hex nuts (two on each side) and carriage 

bolts. Move skid shoes to desired position. See Figure 3-7.

2. 

Make certain the entire bottom surface of skid shoe is 

against the ground to avoid uneven wear on the skid shoes.

3. 

Retighten nuts and bolts securely.