Zoom MRS-1044 Benutzerhandbuch

Here's how the signals that are input from the [INPUT

1]/[INPUT 2] jacks can be sent to a recording track, and

their recording levels can be adjusted.

The [ON/OFF] key enables and disables the jack. When a

key is lit, the corresponding jack is enabled.

Make adjustments so that the [PEAK] indicator flickers

slightly when you play your instrument at its loudest

volume.

With the default settings of a project, the insert effect is

inserted into the input mixer, and a patch suitable for

guitar/bass recording is selected. (For details on how to

select a different patch, refer to p.77.)

If you want to record without sending the sound through the

insert effect, press the effect section [BYPASS/TUNER]

key to bypass the insert effect.

The [REC LEVEL] control adjusts the signal level before it

is sent to the recording track (i.e., after it has passed

through the insert effect). The [CLIP] indicator will light if

the signal clips.

• Adjust the [REC LEVEL] control as high as possible

without allowing the [CLIP] indicator to light.

• The level of the signal sent to the recording track will

change according to the settings of the insert effect

parameters. If you switch insert effect patches or edit the

parameters, you should once again check whether the

recording level is appropriate.

• The precise setting of the REC LEVEL parameter can be

checked by pressing the TRACK PARAMETER section

[PAN] key 

→ INPUT 1 or 2 [ON/OFF] key → cursor [

W

]

key.

The input signal from the input mixer will be sent to the

recording track. You can select record-ready mode for any

one mono track 1 – 6, any one stereo track (7/8, 9/10), or

any two mono tracks (only the track pairs 1/2, 3/4, or 5/6).

The signal flow from the input mixer to the track will

change as follows, depending on the number of selected

recording tracks and on the state of the INPUT 1/2

[ON/OFF] keys.

●

●

Track

Track

Track

Track

Track

Track