Azden 2-Channel Portable Audio Mixer Benutzerhandbuch
3
8) Set the OUTPUT switch (○
7
) to MONO when using one microphone. Set the unused channel level control (○
3
) fully clock-
wise to disable it to prevent noise. When using two microphones, you should normally set the switch to ST for stereo to
keep each channel separated.
keep each channel separated.
9) Activate the 48V phantom power (○
19
) for only those microphones that require phantom power to operate. WARNING: Do
not activate phantom power for dynamic microphones, condenser microphones that do not operate on phantom power,
wireless receivers, mixing boards or any unbalanced device as it may cause damage to both the mixer and connecting de-
vice.
wireless receivers, mixing boards or any unbalanced device as it may cause damage to both the mixer and connecting de-
vice.
10) Leave the AGC switch (○
18
) in ON position for now. Before turning the switch to OFF position to disable AGC, please read
“Using the AGC ON/OFF feature” in this manual for a detailed explanation on how this feature works.
11) Turn the POWER switch (○
1
) on. The power LED (○
2
) should light green.
12) Adjust the input level control (○
3
) for each channel so that the output peak LED’s (○
4
) stay green. Decrease the levels if
they turn red.
13) Plug your headphones into the PHONES jack (○
16
) on the mixer and adjust the MONITOR level control (○
9
) to a comfortable
level. Be sure that you hear audio on both channels from the connected devices.
14) Do a test recording and playback to ensure that the captured audio is satisfactory.
15) To monitor the audio from the camera during playback, connect an AV cable with RCA plugs (not included but most likely
came with the camera) to the corresponding RTN (Return) input jack (○
14
) on the mixer. Attach the other end to the AV out-
put of the camera. Set the MONITOR selector (○
8
) to RTN and you will hear the sounds from the camera from the PHONES
output.