MTD H660G Benutzerhandbuch
12
Shift Rod
To adjust the shift rod, proceed as follows.
•
•
Remove the hairpin clip and slide the shift rod
connector up, to separate the upper shift rod from
the lower shift rod. See Figure 13.
connector up, to separate the upper shift rod from
the lower shift rod. See Figure 13.
•
Place the shift lever into the sixth (6) position.
•
Rotate the shift arm clockwise (from the operator’s
position) as far as it will go.
position) as far as it will go.
•
Thread the upper shift rod downward until the
elbow on its lower end aligns with the hole found in
the lower shift rod.
elbow on its lower end aligns with the hole found in
the lower shift rod.
Figure 13
•
Reconnect the upper shift rod to the lower shift rod
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
IMPORTANT:
Check for correct adjustment of the shift
lever as instructed on page 11, before operating the
snow thrower.
snow thrower.
Auger Control
Refer to
Auger Control Test
on page 9 to adjust the auger
control.
Chute Assembly
The distance snow is thrown can be adjusted by
changing the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase.
changing the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase.
Skid Shoes
The space between the shave plate and the ground can
be adjusted. For close snow removal, place skid shoes
in the low position. Use middle or high position when
area to be cleared is uneven. See Figure 14.
be adjusted. For close snow removal, place skid shoes
in the low position. Use middle or high position when
area to be cleared is uneven. See Figure 14.
•
Adjust skid shoes by loosening the four hex nuts
and carriage bolts and moving skid shoes to
desired position. Make certain the entire bottom
surface of skid shoe is against the ground to avoid
uneven wear on the skid shoes. Retighten nuts and
bolts securely.
and carriage bolts and moving skid shoes to
desired position. Make certain the entire bottom
surface of skid shoe is against the ground to avoid
uneven wear on the skid shoes. Retighten nuts and
bolts securely.
Figure 14
WARNING:
Do not operate this snow
thrower on gravel as loose gravel can be
easily picked up and thrown by the auger
causing injury to the operator and/or damage
to the snow thrower.
easily picked up and thrown by the auger
causing injury to the operator and/or damage
to the snow thrower.
Drive Wheels
The wheels may be adjusted for two different methods
of operation. The adjustment is made by placing the
click pins in one of two different holes on the right side
of the unit. See Figure 15.
of operation. The adjustment is made by placing the
click pins in one of two different holes on the right side
of the unit. See Figure 15.
Figure 15
One Wheel Driving: Insert the click pin only
through the outside hole of the axle (not the rim) on
the right side of the snow thrower. This position
gives power drive to the left wheel only, making the
unit easier to maneuver.
through the outside hole of the axle (not the rim) on
the right side of the snow thrower. This position
gives power drive to the left wheel only, making the
unit easier to maneuver.
Shift Lever
Hairpin Clip
Flat
Washer
Washer
Ferrule
Upper Shift Rod
Hairpin Clip
Lower Shift Rod
Shift Arm
Shift Rod
Connector
Connector
Skid Shoe
Carriage Bolts
Hex Nuts
Inside Hole
in Axle
Click Pin
in Outside Hole