MTD H660G Benutzerhandbuch

15

•

Roll the front and rear auger belts off the engine 
pulley. See Figure 21.

•

Unhook the idler spring from the hex bolt on the 
auger housing. See Figure 22.

•

Back out the stop bolt to allow the belts to slip 
between the bolt and auger pulley. See Figure 23.

NOTE: It may be necessary to loosen the six hex nuts
that fasten the frame to the auger housing. 

•

Lift the rear auger belt from the auger pulley, and 
slip belt between the support bracket and the auger 
pulley. See Figure 22. Repeat this step for front 
auger belt.

•

Replace both auger drive belts by following 
instructions in reverse order.

•

Follow steps 1 through 4 of previous instructions.

•

Pull idler pulley up, and lift belt off engine pulley 
and friction wheel disc. See Figure 21.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley. See Figure 23.

•

Slip belt between friction wheel and friction wheel 
disc. Remove and replace belt. Reassemble 
following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled. See Figure 23.