Troy-Bilt 340 Benutzerhandbuch

References to the right and left side of tiller are determined from 

behind the equipment in the operating position.

• 

One 1⁄2” open-end wrench

• 

One 3⁄8” open-end wrench

• 

Clean oil funnel

• 

Motor oil. Refer to the Engine Operator’s Manual for oil 

specifications and quantity required.

1. 

Identify the forward clutch cable. Fig. 3–1. 

NOTE: Be sure not to kink cables while attaching.

2. 

Hook the “Z” end of the forward clutch cable into the tine 

engagement lever Fig. 3–2.

3. 

Remove the hex screw and bell washer from the right side 

of the frame. Hold the cable guide bracket on the left side of 

frame as it will fall when the bolt is removed. Step 1 in Fig. 3–3.

 

4. 

Insert the handle into tiller frame as shown. Step 2 in Fig. 3–3.

5. 

Insert the bolt through the cupped washer, frame, handle 

and into the cable guide bracket (note the notch in the 

cable guide bracket goes over the flange on the frame.) 

Step 3 in Fig. 3–3. 

• 

One Tiller 

• 

One Handlebar Assembly

• 

One Depth Gage Assembly

• 

One Operator’s Manual

• 

One Engine Operator’s Manual