Troy-Bilt 340 Benutzerhandbuch

2. 

Insert the depth stake assembly into the frame and reinstall 

the two screws removed earlier. Tighten the hex bolts 

securely. See Fig. 3-6.

Secure the pin with the clip removed earlier. The depth stake can 

be placed at various positions. For setup purposes it is suggested 

that the depth stake be assembled with the stake just above or 

level with the ground surface. For further instructions on the 

Depth Stake refer to the Operation Section of this manual.

The tiller is shipped with the wheels adjusted so that the 

machine sits level. The wheels need to be adjusted to meet 

your tilling needs before operation. This adjustment is made 

by removing the clevis pin from the wheel yoke and raising the 

wheels to the desired height. See Fig. 3-7.

6. 

Tighten the bolt securely after securing the handle brace as 

seen in Fig. 3–4.

7. 

Locate the carriage screw, bell washer and hand knob 

packed with your tiller.

8. 

Insert the carriage screw through the bracket on the handle, 

bell washer, handle brace and into the hand knob. See Fig. 3–4.

9. 

Select one of the three handle height positions (three notches 

in the welded handle bracket) and tighten the hand knob to 

secure the handle in the desired position. See Fig.  3–4. Return 

to the lower handle and tighten the hex bolt securely.

1. 

Remove the two screws from the depth stake assembly. 

See Fig. 3-5.