Sears 172.104 Benutzerhandbuch

OPERATION

FORWARD / REVERSE SELECTOR SWITCH with POWER LOCK-OFF (Fig. 2)

To prevent gear damage, always allow the chuck to come to

a complete stop before changing the direction of rotation.

CAUTION:

The direction of bit rotation is forward or reverse and is controlled by a selector switch

located above and to the rear of the trigger switch. When holding the drill / driver in the

normal operating position, (and viewed from the back of the drill/driver see Fig 2 a, b, c),

the selector switch should be positioned (pushed) all the way to the RIGHT, for

FORWARD (b) or normal drilling / driving, and positioned (pushed) all the way to the LEFT

for REVERSE (c) to remove drill bits and back out screws.
The third position for the selector switch is located in the CENTER (a). This position keeps the

trigger switch from working, locking the power “OFF”. Setting the selector switch in the “OFF” or

CENTER position helps reduce the possibility of accidental starting when the tool is not in use.

Fig. 2

FORWARD

POWER LOCK-OFF

REVERSE

REMOVE BATTERY PACK FROM

DRILL / DRIVER (Fig. 3)

1. Place the Forward / Reverse Selector

Switch with Power Lock-Off into the

center position to lock the power off

(see Fig. 2, above).
2. Locate the latches on each side of the

battery pack. Depress (squeeze in)

latches and pull battery pack out of

drill.

10-4-07 Drill
10300-10400

Fig. 3

OPERATION cont.

CHARGING THE BATTERY PACK (Fig. 4 and 4a)

The battery pack for this tool has been shipped in a low charge condition to prevent

possible problems. Therefore, you should charge overnight prior to use.

1. Charge battery pack only with the charging

stand/ transformer that was supplied with

this drill / driver.
2. Make sure power supply is normal

household voltage, 120 volts,

60 Hz, AC only.
3. Connect charging stand’s transformer to power

supply.
4. Place battery pack in charging stand. Align

raised rib on battery pack with groove in

charging stand (See Fig. 4).
5. Press battery pack down into charging stand

making sure contacts are engaged properly.
6. The charging stand has two (LED) indicator

lights, one green and one red.
When the charging stand’s transformer is

plugged into a power outlet, the green LED

will light, indicating that the charger is

operating properly.
When a battery pack is put into the charging

stand/transformer, the red LED will light,

indicating that the battery pack is charging

properly (see Fig. 4a).
Both lights will remain “On” as long as

the charging stand/transformer is plugged

in and the battery pack is charging.

NOTE: Batteries will not reach full charge the first time they are charged.

Allow several cycles (operation followed by recharging) for them to become

fully charged.

NOTE: If the charging stand LED lights do not operate properly, or the charging

stand does not charge the battery pack, return the drill/ driver, charging

stand/transformer and battery pack to your nearest Sears store or other

Craftsman outlet to have it replaced.

When the battery pack is charged and removed from the charging stand, the red light

will go Off. The green LED will stay “On” as long as the charging stand/transformer

is plugged into a power supply and operating properly.

7. After normal use, 3 hours or less of charging time is required to fully recharge battery

pack. If battery pack is completely discharged, 6 hours or longer of charging time is

required to fully recharge battery pack.

Fig. 4a

Green

LED

Green

LED

Red

LED

Fig. 4