Senco PC2016 Benutzerhandbuch

14 

 

 

 

 

      

 

                 Senco

®

 Electric Air Compressor Manual 2004

REMEDY 

Adjust pressure regulator knob to proper setting or 

replace. 

 

Clean or replace. 

 

Check for leaks and repair. 

 

Replace with larger hose or connectors. 

 

Tighten or replace. 

 

Check the accessory air requirement. If it is higher 

than the CFM or pressure supply of the air  

compressor, you need a larger air compressor.

PROBABLE CAUSE 

Pressure regulator knob not turned to high enough  

pressure or defective pressure regulator.
Restricted air intake filter.
Air leaks. 
Hose or hose connections are too small or long. 

 

Slipping belt. 

 

Air compressor is not large enough for air require-

ment.

REMEDY 

Change oil and move air compressor to a less humid 

environment. 

PROBABLE CAUSE 

Water in oil due to condensation.

REMEDY 

Clean or replace. 

 

Drain air tank and measure pump up time.  Compare 

to specifications.  If longer, remove pump head and 

inspect valve plate, clean or replace. 

 

Clean or replace. 

PROBABLE CAUSE 

Restricted air intake filter. 

Defective (reed) valve. 

 

 

Restriction in pilot valve.

REMEDY 

Clean or replace. 

 

Do not incline the air compressor more than 10° in 

any direction while running. 

 

Drain oil.  Refill to proper level with Senco PC0344 

oil. 

 

Clean. 

 

Repair. 

 

Contact Senco Customer Service 800-543-4596.

PROBABLE CAUSE 

Restricted air intake filter.
Air compressor on unlevel surface. 

 
Crankcase overfilled with oil. 

 
Plugged oil dipstick vent. 

 

Oil leaks. 

 

Worn piston rings or scored cylinder.

Excessive oil consumption in pump. 

REMEDY 

Drain air tank after every use.  Drain air tank more 

often in humid weather and use an air line filter.

PROBABLE CAUSE 

Condensation in air tank caused by high level of at-

mospheric humidity or air compressor is not run long 

enough.