KYOCERA 4550ci Benutzerhandbuch

The procedure for using Combine mode copying is explained below.

Press the Copy key.

Place the originals on the platen.

Press [Layout/Edit] and then [Combine].

Press [2 in 1] or [4 in 1], and choose the page layout 
of Layout.

Press [Border Line] to choose the type of the lines 
to indicate page boundaries. Press [OK].

Press [Original Orientation] to choose the 
orientation of the originals, either [Top Edge on Top] 
or [Top Edge on Left]. Then press [OK].

Press [OK].

Press the Start key. Copying begins.

If the original is placed on the platen, replace the 
original and press the Start key.

After scanning all originals, press [Finish Scan] to 
start copying.

Shift the original image to make space on the copy for binding on the left (right) or top (bottom) side.
When you copy onto paper different from the original size, you can center the original image on the paper.
The following margin widths are available.

When duplex copying, you can also specify the margin on the back side.

When [Auto] is selected, an appropriate margin is applied automatically on the rear page depending on a margin 
specified for the front page and a binding orientation.

Enables you to specify the front and back settings separately.

You can set the default margin width. Refer to Margin Default on page 9-24 for details.

Status

Copies

Cancel

OK

Combine

Add Shortcut

Layout

4 in 1

2 in 1

Left then

Down

Original

Orientation

Off

Border Line

Down then

Right

Down then

Left

Right then

Down

Top Edge

on Top

None

10/10/2010  10:10

50%
A4

A4

Preview

Original
Zoom
Paper

:
:
:

Inch Models

-0.75 to 0.75" (in 0.01" increments)

Metric Models

-18 mm to 18 mm (in 1-mm increments)