Sharp FO-DC500 Benutzerhandbuch
Sending an Image Using a Rapid Key
89
3. Netw
or
k
Scanner
8
Press
. The document is scanned and transmitted.
START/
ENTER
ENTER
Sending an Image Using a Rapid Key or
Speed Dial Number
Speed Dial Number
Sending an image using a Rapid Key
Use this procedure to scan a document and send the image to an E-mail, FTP,
or Desktop destination that has been stored in a Rapid Key.
or Desktop destination that has been stored in a Rapid Key.
Important: To use this procedure, the setup procedures outlined on page 73
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 84 of this
manual.
must be completed. In the case of Scan to E-mail, this includes setting a
default sender as explained in the procedure beginning on page 84 of this
manual.
♦
If you are sending the image to an e-mail destination and need to change
the subject, use the procedure on page 84.
the subject, use the procedure on page 84.
1
Load the document(s).
•
SEND READY will appear in the
display.
display.
•
Press
and/or
to
set
the resolution and contrast if needed.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
The default resolution is FINE. Note
that STANDARD and SUPER FINE are
primarily for faxing and are not
recommended for scanning.
2
Press the appropriate Rapid Key.
•
The name of the recipient will appear in the display. (If the destination is not
correct, press
.)
•
If the destination is an FTP or Desktop destination, or if the destination is
an e-mail destination and you don’t need to enter a message or change any
of the e-mail options, this completes the procedure.
an e-mail destination and you don’t need to enter a message or change any
of the e-mail options, this completes the procedure.
RESOLUTION
CONTRAST
STOP