Sharp FO-DC500 Benutzerhandbuch

Sending an Image Using a Rapid Key 

3. Netw

or

k 

Scanner

Use this procedure to scan a document and send the image to an E-mail, FTP, 
or Desktop destination that has been stored in a Speed Dial number.

Important: To use this procedure, the setup procedures outlined on page 73 
must be completed. In the case of Scan to E-mail, this includes setting a 
default sender as explained in the procedure beginning on page 84 of this 
manual.

♦

If you are sending the image to an e-mail destination and need to change 
the subject, use the procedure on page 84.

•

SEND READY will appear in the 
display.

•

Press 

 and/or 

 to set 

the resolution and contrast if needed. 
The default resolution is FINE. Note 
that STANDARD and SUPER FINE are 
primarily for faxing and are not 
recommended for scanning.

•

If you enter less than 3 digits for the Speed Dial number, press 

 to 

complete the entry.

•

Check the display to make sure the destination shown is correct (if not, 

press 

 and repeat Step 2).