Panasonic AJ-HRW10G Benutzerhandbuch

11

This unit is constructed to allow the HDDs to be 
installed on 5-inch bay units, but its design does not 
improve the HDD drop resistance or impact resistance 
performance.  Remember to take extra care when 
handling the bay units.
•  The 5-inch bay units are not packed with the storage 

unit. Give due consideration to the applications 
for which they will be used, obtain bay units with a 
sufficient shock and vibration resistance, and install 
them.

There are cushions on the legs to absorb the vibration. 
However, please understand that no guarantee against 
damage or failure.

The unit is designed for use with typical HDDs 
installed. To minimize any risks associated with 
HDD damage, loss of data on HDDs, or interrupted 
operation, refer to the HDD user manual for 
information on installation and use. 
•  When moving the unit, after setting the rear POWER 

switch to OFF be sure to wait until the HDDs stop 
rotating (about 2 minutes) before moving the unit to 
avoid subjecting the unit to shock or vibration.
(After the unit is turned OFF, HDDs continue spinning 
from inertia for a while.)

Before moving the storage unit, be absolutely sure to 
press the EJECT buttons and set it to in position.

When moving the unit, protect the front panel with the 
front cushion.

Surface fasteners 
(with adhesive tape)

Magnet

Deciding on where the 
surface fasteners will be 
mounted.

Attaching the magnet

(Continued on next page)