GE 68K System Benutzerhandbuch
GE Energy Services
68K System Monitor
User's Guide
SWM0023 1.00 2
General
3-40
Full Release
HT - HDLC Test
Platform
o
CPM
þ
D20
D20 Base
D20 Base
þ
D20 ME
D20 Base
D20 Base
o
D20/200
CCU Base
CCU Base
þ
D20/200 ME
CCU Base
CCU Base
o
D25
Description
Use this command to transmit specific application messages over the HDLC
communication link.
Note:
communication link.
Note:
Because you must assemble these messages by hand, you can not use the
command effectively unless you know the protocol used by the D.20
application.
command effectively unless you know the protocol used by the D.20
application.
Syntax
Below is usage and syntax information for this command
Command Format
ht /(c | m | r | s | w)
Variables
/c
= configure the link parameters
/m
= define the application message
/r
= read (monitor) the link
/s = display
configuration
status
/w
= send an application message
Parameters
None
Example
None required
Special
Considerations
Considerations
This command is not available on the CPM.
This command is not available if the D.20 (B003) application
is active.
is active.