Compaq COM-2(PC)F Benutzerhandbuch
How to Use the Board
COM-2(PC)F
15
Compatible Mode Installation Procedure 1
It can’t be used with Compatible Mode when API-SIO(98/PC)NT
of packing together is used for API-PAC(W32).
of packing together is used for API-PAC(W32).
1. Set the operation mode (I/O address) and interrupt level for the
COM-2(PC)F. Set the COM-2(PC)F switch and jumpers as
described in Hardware Setup. Set an interrupt level that is not
currently used by the computer.
described in Hardware Setup. Set an interrupt level that is not
currently used by the computer.
2. Insert the COM-2(PC)F in an expansion slot and turn on the
power to the PC.
3. After Windows 2000 starts, select [Control Panel] from
[My Computer] and start the [Add/Remove Hardware].
4. Click [Next >] in response to [Welcome to the Add/Remove
Hardware Wizard] in the Add/Remove Hardware Wizard.
5. Select [Add/Troubleshoot a device] in response to [Choose a
Hardware Task].
6. The next, select [Add a New Device] and click [Next].
7. Select [Yes] in response to [Do you want Windows to search for
your new hardware ?], and click [Next].
8. It confirms that two [Install Communications Port] sentences are
indicated on the [Detected Hardware], and click [Next].
9. After rebooting, use the procedure described in the "Check
Resources" section below to check the interrupt level assigned
to the COM-2(PC)F. If the value is different to the level set on
the jumper, correct the setting in the OS.
to the COM-2(PC)F. If the value is different to the level set on
the jumper, correct the setting in the OS.
10. When installing by this method, the COM-2(PC)F channels are
installed as standard serial ports (COM*).