Ricoh 2000 Benutzerhandbuch

Placing Originals

41

C

Specify the destination, and then press the {Start} key.
The Stamp indicator goes out when transmission has been finished for Immedi-
ate Transmission or when scanning has been finished for Memory Transmission.

❒ This stamp indicates that the original has been successfully stored in memory

for Memory Transmission, or successfully sent by Immediate Transmission.

❒ When the stamp starts getting lighter, replace the cartridge.
❒ If a multi-page feed or paper jam occurs, the originals are not sent properly

and not stamped. If you find a page that is not stamped, send only that
page again. 

❒ A paper jam during Parallel Memory Transmission may cause the trans-

mission to fail even if stamping is performed.

❒ You cannot turn the Stamp function on or off while an original is being

scanned.

Reference
“Fax Features”, General Settings Guide
“Adding Paper and Replacing Toner”, Troubleshooting