Zoom X4 Benutzerhandbuch

Chapter 2: Advanced Setup Options

17

Your service provider will supply the Permanent Virtual Circuit
(PVC) setting for your basic Internet connection. You can define

additional PVCs for services such as telephony or to connect to a

managed Virtual Private Network (VPN) if available in your area.
Consult your service provider.

Enabled by default.

Supplied by your service provider (reference
table appears on page 5).

Supplied by your service provider (reference
table appears on page 5).

Most providers use dynamic IP addressing;
only providers using Bridged or Routed IP
Encapsulation can use static IP addresses. If
your provider has given you a static IP
address, enter it here.

For static IP address users only (see above):
Enter the subnet mask of the static IP
address given to you by your service provider.

No. of virtual circuits that can be set up: 1-7.

Note: You must scroll down to the bottom of the page to reach

the Virtual Circuit field and select a number from the dropdown

list to identify a PVC. The number 0 is reserved for the Basic Setup

settings preconfigured for your provider. Be sure to click Save

Changes and then Write Settings to Flash and Reboot. Once

you have set up multiple PVCs, you can switch between them by

selecting a different number from the Virtual Circuit dropdown

list and clicking Save Changes and Writing Settings to Flash
and Reboot.
Once you have set up multiple PVCs, you can switch between
them by selecting a different number from the Virtual Circuit

dropdown list and clicking Save Changes and Writing Settings

to Flash and Reboot.