Zoom X4 Benutzerhandbuch
Chapter 2: Advanced Setup Options
19
PPP (Point-to-Point Protocol)
PPP is the most widely used protocol for authenticating your
connection to the Internet. Should you change service providers,
connection to the Internet. Should you change service providers,
you may need to change the data in these fields. Note: These
settings also appear on your Basic Settings page.
User Name
Supplied by your service provider.
Password
Supplied by your service provider.
Service Name
Optional; supplied by your service provider.
Disconnect Time
ADSL connection will be dropped after the
ADSL line is idle for a certain amount of time
(measured in seconds). Select 0 to ensure
that you won’t be disconnected.
ADSL line is idle for a certain amount of time
(measured in seconds). Select 0 to ensure
that you won’t be disconnected.
MRU
Maximum Receive Unit. Largest physical
packet size, in bytes, that a network can
accept. Any messages larger must be
fragmented. Default is 1492.
packet size, in bytes, that a network can
accept. Any messages larger must be
fragmented. Default is 1492.
MTU
Maximum Transmission Unit. Largest
physical packet size, in bytes, that a network
can send. Any messages larger must be
fragmented. Default is 1492.
physical packet size, in bytes, that a network
can send. Any messages larger must be
fragmented. Default is 1492.
MSS
Maximum Segment Size. Largest data
segment, in bytes, allowed within each IP
packet. Default is 1432.
segment, in bytes, allowed within each IP
packet. Default is 1432.
Authentication
PPP user authentication method. Default is
Auto; you can specify CHAP or PAP only.
Auto; you can specify CHAP or PAP only.
Automatic Reconnect
Enabled by default. Uncheck this box if you
do not want to be reconnected automatically
if the ADSL connection is terminated
unexpectedly.
do not want to be reconnected automatically
if the ADSL connection is terminated
unexpectedly.
DHCP (Dynamic Host Configuration Protocol)
DHCP is disabled by default. Typically, you should not need to
change your DHCP setting. Do so only if your service provider
requests it.
requests it.
DHCP client enable
Check this box only if instructed to by your
service provider.
service provider.
Host Name
If necessary, supplied by your service
provider.
provider.