Wacom 21UX Benutzerhandbuch

Installation
Page  18

STEP 1: DISPLAY INSTALLATION

In this step, Cintiq is installed as a display on your system.

Important: Never connect or disconnect the video or power cables while your computer or pen display 

are powered on.  This can damage the display or video card.

1.

Turn off your computer.

2.

If your computer has only one video connector, unplug your previous monitor or add a second 
video card.  Determine if your computer has a digital (DVI) or analog (VGA) connector, and set the 
DVI/VGA switch located on the back of Cintiq for the video connection you are using.  Move the 
switch toward the tablet edge for Digital (DVI-I or DVI-D), and move it toward the OSD buttons for 
Analog (VGA).  See  – A –  in the connection diagram on page 19.

3.

Making sure to tighten the connector thumbscrews, follow the below instructions for your video 
connector.  See  – B –  in the connection diagram.

4.

Connect the power adapter to Cintiq.  See  – C –  on the next page.

5.

Connect the adapter power cable and plug into an AC outlet.  See  – D –  in the connection 
diagram.

6.

Turn on Cintiq.  The power LED will light orange.

For DVI-I operation, plug the Cintiq video cable into the DVI-I connector of your 
video card.

For DVI-D operation, plug the Cintiq video cable into the DVI-D to DVI-I adapter 
supplied with Cintiq, and then plug the adapter into the DVI-D connector on your 
video card.

For VGA operation, plug the Cintiq video cable into the VGA to DVI-I adapter 
supplied with Cintiq, and then plug the adapter into the VGA connector on your 
video card.

If connecting to a Mac Mini DisplayPort, you will need to obtain an appropriate 
adapter.  For best results the Apple Mini DisplayPort to Dual-Link DVI Adapter is 
recommended.  Adapters can be purchased at various retail outlets and through 
the online Apple Store.
Connect the adapter between the Cintiq video cable and your Macintosh.

DVI-I connector

DVI-D connector

VGA connector