Siemens 2000592-001 Benutzerhandbuch

Protocol and Addressing 

Open Systems standard TCP/IP protocol and addressing 
(Transmission Control Protocol/Internet Protocol); Full Class A, B and 
C addresses and subnet masking supported 

Wiring Connections 

•  Two part connectors with screw-terminals provided for cable 

connection 

•  Fiber Optic Coupler for Fiber Optic Connections 

DataNET Option, Standard  
Cable 

•  Cable connection by Belden 9182 (single pair) or Belden 

SSD1743 (two pairs) or equivalent; two pairs of wires are 
required to support redundancy 

•  Two pairs of cable is required to support redundancy 

•  Shielded cable or unshielded cable in conduit is required for 

conformance to CE certified installation 

•  Two part connectors with screw-terminals provided for field 

connection 

DataNET Option, Fiber Optic 
Cable 

•  Fiber optics connection by 62.5 multi-mode cable corresponding 

to 10BaseFL Ethernet specification 

•  Two pairs of fibers are required to support redundancy 

•  Type ST mating connectors provided for field connection 

•  Approximately 3 mbps base transmission rate; uses dedicated 

transmission technique that does not require collision detection to 
achieve high data throughput efficiency 

•  Maximum Length 5000 feet ( 1.7km) 

Fiber Optic Coupler 

•  Two (Tx, Rx) ST-Style Connectors (Amp type 2.5mm Bayonet) 

 

 

Serial Port 

•  Standard RS-232 port for attachment of a laptop computer, for 

configuring IP Addresses and troubleshooting. 

 

The Table below compares key communication features between using 
Advance Data Hiway, Ethernet, or DataNET. 

Feature Advance 

Data 

Hiway 

Ethernet  DataNET 

Speed 

14.2 KB/Sec 

10 M baud 

2. 048 M baud 

Redundant Yes 

No 

Yes 

Number of Units in 
Maxum System 

248 1200 

1200 

 

•  3