Siemens 2000592-001 Benutzerhandbuch

DataNET Copper Connections

Before You Begin

This section provides instructions for connecting the Maxum to a
DataNET network. All DataNET connections are made to the ANCB. The
DataNET connections can be either copper or fiber.

The ingress wiring method (conduit or cable glands) and which cable
type you use is dependent upon the site requirements. Review the Site
Wiring Requirements page 8 to ensure that you are using the correct
cable and wiring method.

Refer to ANCB Description page 46.

J12

10B ase2

10B aseT

J 10 P ort 1
For ANCB: Ju mpers on
Botto m 3 Po sition s O n ly

J11 Port 2
For ANCB Ju mp ers on
Botto m 3 po sition s O n ly

Config Port
RS232
57.6 KB

J2 Ju m p er Co nn ection s

• • 150 Ohm
• • 120 Ohm Port 2 (DN)

• • 100 Ohm

•   • 150  Ohm
•   •  120 Ohm     Port 1(DN)
• •  100 Ohm

Default S etting on 150 o hm
Position s

Board
RESET

O peration LED S

J5
Default on Pins 1 &2

Figure 1-1: ANCB Board
Jumper Settings

NAU Installations

For rack mount units the SYSCON connections are visible at the rear of
the NAU. If you have a wall mounted unit you must first remove the front
or side safety box access covers to see the SYSCON connections.

Instructions

Step Action

Turn off AC Power (Mains) to the unit.

Route incoming the DataNET copper cables to the ANCB
in accordance with national or local electrical codes and
regulations.

• Installation

2000592-001