Eicon Networks Adapters Benutzerhandbuch

 

     Installing Your Server Adapter

 

The DIVA Server PRI needs up to 20 Watts of power. If you have 
several adapters installed in your system, make sure that the power 
supply will not be overloaded when you install the DIVA Server PRI.
PRI signals can have telephone network voltages (TNV). Therefore, 
PRI lines should be installed and maintained by service personnel only. 
It may be hazardous if your computer is not properly plugged in and 
grounded. This applies particularly to users in North America and 
Australia. 

 

For your safety, turn off the power to your computer and all peripheral 
devices.

 

Drain static electricity from your body by touching the metal chassis (the 
unpainted metal at the back of your computer). 

 

Remove the power cord from your computer.

 

Remove the cover of the computer as described in your computer’s manual.

 

 The default jumper settings are 

shown below. Verify that the two jumpers on your adapter use the default 
settings:

 

Firmly insert the adapter into a free PCI slot, allowing the retainer to slide 
between the guides. Make sure that the adapter does not touch the CPU, 
memory modules, or any other parts on the motherboard. 

 

To avoid damaging your hardware, insert the DIVA Server PRI 
adapter only into a PCI slot. Inserting the adapter into any other 
type of slot can damage your adapter, your computer, or both.

 

Firmly secure the adapter with the screw (or clip), to ensure that the adapter 
is properly grounded to the computer’s chassis.

 

Replace the cover of the computer as described in your computer’s manual.

JP 701

JP 702