Enterasys Networks RBTSA-AB Benutzerhandbuch

C

HAPTER

 3: C

ONFIGURING

 

THE

E

THERNET

 A

DAPTER

Under System Configuration, click SNMP to display and change settings 
for the Simple Network Management Protocol. 

To communicate with the Ethernet Adapter, the SNMP agent must first be 
enabled and the Network Management Station must submit a valid 
community string for authentication. Select SNMP Enable and enter data 
into the fields as described below. When you are finished, click Apply.

You can use the Access Control List to allow or prohibit access to the 
wireless network from Ethernet clients.

Follow these steps to build the Access Control List:

1 Under System Configuration, click Access Control List.

2 On the Access Control List page, click Add.

The Access Control List New ACL page appears.

3 On the New ACL page, enter the MAC address of the client you want to 

add to the Access Control List, select the permission type, and click the 
Add button to substantially add it.

4 Repeat steps 2 and 3 for each client.

5 Select the System Default Mode:

■

Allow—allows the client to access the  Ethernet Adapter.

■

Deny—prohibits the client from accessing the Ethernet Adapter.

Table 13   SNMP Settings

SNMP

Enables or disables SNMP. 

Contact

Sets the location string that describes the system location. 
Maximum length: 255 characters.

Community Name 
(Read Only)

Specifies a community string with read-only access. 
Authorized management stations are able to retrieve MIB 
objects. Maximum length: 23 characters.

Community Name 
(Read/Write)

Specifies a community string with read-write access. 
Authorized management stations are able to both retrieve 
and modify MIB objects. Maximum length: 23 characters.

Trap Destination 
IP Address

Enter the IP address of the trap manager that will receive 
these messages.

Trap Destination 
Community Name

Enter the community name of the trap manager that will 
receive these messages.